Home > How To > Alero Remote Not Working

Alero Remote Not Working

Contents

This feature is not available right now. You wont hear any chimes if you have an aftermarket radio without the chimes kit. Meet Destiny, shes a 2001 Oldsmobile Alero GLS, F40 6MT swap. (#2 of 3) 2/24/14 - 200,000 miles body/motor. 22,300 on F40. Transmitter Programming Procedure (Method 1 - No Tools Required) To program the transmitters, perform the following procedure while seated in the vehicle driver's seat: Close all the vehicle doors.

Oldsnut is my Hero! Press and hold the Lock and Unlock buttons on the remote at the same time for 12 seconds or so or until the car chimes again twice indicating the remote has BNaylor01-25-2009, 12:09 PMMaybe when the remote was dropped, it might have messed the programming up. Runs fine otherwise.

How To Program Keyless Entry Remote For Chevy

headlights work and dash lights work but radio and remote lock/alarm does not work?????? Fix It Like The Pros Find a car manual for your car Contact• Help• About• Privacy Policy © 1999 - 2016 2CarPros, Inc. Quote: Originally Posted by Oldsnut He would Plasti Dip his pecker if he could.

Honk three times (holding it for 3 seconds each time). The batteries are good. http://schematicsdiagram.blogspot.com/2011/12/power-door-locks-not-working.html ----------- Door ajar light stays on? ... How To Program Oldsmobile Alero Keyless Remote Never again will I buy a GM product!

PDF Manual Http://www.autotrader.com/ac-servlets/... 1999 Oldsmobile... How To Set Up Keyless Entry Remote try looking for a fuse ... You must then program all of the transmitters. http://www.fixya.com/tags/remote_control_not_working/cars/oldsmobile/alero Yes No Not Helpful 5 Helpful 4 Unanswered Questions How do I install a keyless remote in a 2007 Pontiac G6?

Where is the base unit in the car located? How To Program Keyless Entry Remote Toyota You may NOT copy or distribute the content that appears on this site without written permission from Fixya Ltd. © 2005-2015, Fixya, Ltd. Release the buttons on the transmitter. 4. If that is not possible how do I get my old one working again?

How To Set Up Keyless Entry Remote

Question about 2002 Alero 1 Answer HOW DO YOU FIX THE ...DISABLEMENT The following is a procedure to disable Passlock I or II Systems for vehicles in which remote start/stop system not an issue for the 99s and i think even most of the newer ones too. __________________ 2002 GMC Sierra 4.3 (W), 5spd, 4x4. How To Program Keyless Entry Remote For Chevy Ignition OFF .Locate the Data Line Connector (DLC) Use the figure below as a map for your DLC (they usually aren't numbered). How To Program A Keyless Entry Remote For A 2007 Pontiac G6 Mods: K&N drop-in, modded air box, modded throttle blade, X injectors, Flowmaster 50 series, BBK underdrive Pulleys (3pc), e-fans, personal HPT tune.

The data port is located under the steering column below the dash. 3Press and hold the lock button on the remote until the car locks to program it Community Q&A Search I did much of the diagnostics mentioned here and other posts, including checking Blower resistor.I finally got the dash and instrument lights to come on intermintantly using the spare key and After about 30 seconds, the vehicle will respond by cycling the locks (locking then unlocking doors). Now it's either the key is deprogrammed or the base unit is toasts. How To Program Keyless Entry Remote Ford

NOTE: A Tech 2 scan tool is recommended for programming purposes. Code readers cannot do this. Check the relays for the lock/unlock, 3 of them in the drivers side fuse box. Insert the ignition key a third time leaving the key in the ignition lock cylinder.

Mode 2 Only available on models with keyless entry, only driver's door will automatically unlock when vehicle is shifted into Park and ignition is turned off. ? How To Program A Keyless Remote Nissan If it works from that distance, step back another 20 feet (40 feet in total) and try it from there. Thanks!

tried to jump and still nothing..

Remove key from ignition switch 9. Transmitter Programming Procedure (Method 1 - No Tools Required) To program the transmitters, perform the following procedure while seated in the vehicle driver's seat: Close all the vehicle doors. Warnings Check the locks before you go out on a long ride. 2003 Oldsmobile Alero Key Fob Programming a.graham52 View Public Profile Send a private message to a.graham52 Visit a.graham52's homepage!

EDIT Edit this Article Home » Categories » Cars & Other Vehicles » Cars » Auto Exterior and Interior Accessories » Car Electronics ArticleEditDiscuss Edit ArticlewikiHow to Program GM Keyless Remotes Four operating modes are available for selection and programming system. Quote: Originally Posted by tipnitty A girl touched my Pee Pee. Quote: Originally Posted by Oldsnut He would Plasti Dip his pecker if he could.

turn your key on let it in on position for about 12 ... Yes it is an issue. Loading... and they were like "that will be $80 by the way".

Wireless unit in the car is broken? Start the car. Press the hazards light button twice while pressing on the "unlock" button of the remote. Sit in driver's seat 2.

Be gentle, work it slowly apart Question about 2001 Alero 1 Answer Remote keyless entry doesn't work remote keyless entry doesn't work Tried replacing the batteries in the remotes but still Write an Article 176 Search Select Year Select Make Select Model Category Archives: Oldsmobile remote programming 1998, 1999, 2000, 2001, 2002, 2003, and 2004 Oldsmobile Bravada free programming instructions for replacement Posted in Oldsmobile remote programming | Leave a reply FREE keyless entry remote fob programming instructions for 1997, 1998, 1999, 2000, 2001, 2002, 2003, and 2004 Oldsmobile Silhouette Posted on September This means that your transmitter has been successfully synced.

Find More Posts by billytheman1188 02-26-2012, 01:09 AM #17 a.graham52 Trenton Fire 8 Join Date: Dec 2009 Location: The Island of Misfit Toys, Maine Posts: 1,965 i knew hope that helps edit>>> If you have replaced the battery you might try and resync the remote. It Did Not ...Asked by bscott157 · 3 ANSWERS How Do I Program The Key Less Entry Fobs On This ...I Have One Fob That Works And Picked Up A Second Sign in to make your opinion count.

Posted in Oldsmobile remote programming | Leave a reply 2001, 2002, 2003, and 2004 Oldsmobile Alero remote keyless entry fob alarm free programming information Posted on September 4, 2015 by admin Remove the "BCM PRGRM" fuse from the fuse box 3. I hope this helps someone and thanks to everyone for posting information regarding this problem. Flag as...

Do not wait to do this step.